Advertisement
For NoEOmaI cooling
1. Set SELECTOR switchat HIGH
COOL.
2. Set THERMOSTATcontrol at
desirednumber(ustiy the midpoint
is a good starting position). If room
temperature is not satisfactoryafter
a reasonabletime,setthetemperature
control at a higher number for a
cooler room or at a lower number
for a warmer room.
~0~
NIafimumCooling
1.
Set SELE~R
switch at HIGH
COOL.
2. SetTHERMOSTATcontrolat 10.
3. Set VENTILATION control at
CLOSE position.
4. Shift FAN switch to
CONTINUOUS.
For Quieter
operation
1. Set SELECTOR switch at LOW
COOL.
2. Set THERMOSTAT control at
desired number.
3. Set VENTILATION control at
CLOSE position.
4. Shift FAN switch to desired
position—CONTINUOUS or
H'LE.
For P4igM:time op@I"atiaE3
During the cooler evening hours,
it is recommended that you set the
SELE~OR at LOW COOL for
very quie~operation and the
TIIERMOSTAT control at mid
range (5 or 6).
EorEtireIme
Temperatklres
For greatest economyand best
performance, we suggestyou
alwaysset the SELE~R
at
HIGH COOL in extremelyhot
weather.
For air
circulation
and
filtering
Without
cooling
Set SELE~R
switch at FAN
ONLY
Forfan only operation, the F~
switch located behind thefront
grille (seepage 4) must be in the
CONTINUOUSposition.
For ventilation
Whethercontrolsare set for cooling,
heatingor fan only operation,setting
VENTILATION control at OPEN
lets room air be exhaustedto the
outside. This is helpful in removing
stale air, smoke or odors from the
room, and permits outdoor air to
enter throughnormalopeningsin the
house.However, c oolingeffmtiveness
is reduced when this control is set
at OPEN, so we suggestyou don't
keep it there long—especiallyin
hot, humid weather.
~0~
NormalHeating
1.
Set SELE~R
switch at HIGH
HEAT.
2. Set THERMOSTAT control at
desirednumber (usuallythe midpoint
is a good statiing position). If room
temperature is not satisfactory after
a reasonabletime, setthe temperature
control at a lower number for a
warmer room or at a higher number
for a cooler room.
Ek:TRga'<!z?':11'w' ::fio%i-i~a
,Ix: LJ,L-bQk
J..;...> = W==W=
.J,. a
1. Set SELE~OR
switch at HIGH
HEAT.
2. Set TI+ER~tiOSTATcontrol at 1.
3. set '*~ ENTILATIoN control at
CLt~SE position.
~!,. S hifi lgl~ I>? switch to
$:~lr=JTIi'J7d$g~Js.
up-and-down
air
direction:
Adjustlouvers with your fingertips
to direct dischargedair up, down or
straight ahead.
Side-tO-~ideair direction: Adjust
louvers with your fingertips to
direct discharged air to the left, to
the right or straight ahead.
..— ..——.——
...-..——.—
.—. . —.. ————
.—.—. - . ..
Advertisement
