Asus INTEL TUSL2 User Manual page 37

3. HARDWARE SETUP
11) IDE Activity LED (2-pin IDELED)
This connector supplies power to the cabinet's IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE connectors
will cause the LED to light up.
COM1
®
TUSL2
TUSL2 IDE Activity LED
12) Power Supply (PWR_FAN), CPU (CPU_FAN), Chassis (CHA_FAN) Fan
Connectors (3 pins)
These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate
the fans so that the heat sink fins allow airflow to go across the onboard heat
sink(s) instead of the expansion slots. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan's plug to the board taking into consid-
eration the polarity of the connector.
NOTE: The "Rotation" signal is to be used only by a specially designed fan with
rotation signal. The Rotations per Minute (RPM) can be read directly from the
ASUS iPanel or monitored using a utility such as ASUS PC Probe (or Intel LDCM.)
WARNING!
The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
COM1
®
TUSL2
TUSL2 12-Volt Cooling Fan Power
TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.
IDELED
Rotation
+12V
GND
GND
+12V
Rotation
Rotation
+12V
GND
ASUS TUSL2 User's Manual
CPU_FAN
PWR_FAN
CHA_FAN
37