Vent Control Assembly Removal; Capacitor Removal - Amana 10c5ez Service

Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and
discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require
power to be connected. Ensure all earth wires are connected before certifying unit as repaired and/or
operational.

Vent Control Assembly Removal

To remove vent control assembly:
1. Remove outer case (see paragraph Outer case
Removal).
2. Remove top cover.
3. Remove 1/4 inch screw securing vent door to barrier
control.
4. Remove 1/4 inch screw securing vent door slide to
control panel.
5. Lift vent control assembly out and away from chassis.
Top cover
Vent door
Vent
door
slide
Vent Control Removal
RS5100002 Rev. 0
!
WARNING

Capacitor Removal

To remove capacitor:
1. Remove outer case (see paragraph Outer case
Removal).
2. Discharge capacitor through 10,000 ohm resistor.
3. Disconnect wires attached to capacitor.
NOTE: Before disconnecting or removing wires, always
note position or location of wires. Ensure all
disconnected wires are reconnected to proper
location.
4. Remove 1/4 inch screw securing capacitor mounting
strap to partition panel.
5. Pull capacitor strap away from capacitor, then pull
capacitor out and away from chassis.
Capacitor strap
34
Partition panel
Capacitor
Capacitor Removal