Table of Contents
Advertisement
Operation
Vent Control
Open or close the vent by sliding the vent control leverto the
appropriate setting.
EXHAUST- This setting opens the vent to move indoor air
out.
Note: To conserve energy, the unit should be set to the
FAN ONL Ymode when using this setting.
CLOSED - In this position the vent is closed and room air
is recirculated and filtered. This position should be used for
all normal cooling operations (see underlined cooling op-
tions on control panel).
ENERGYSAVER
(HIGH, MED and LOW)-
ENERGY SAVER mode provides the most
energy efficient use of your room air condi-
tioner.
I n ENERGY SAVER mode, thefan stopswhen the
compressor stops cooling. This feature can be used with
SMART COOL or cooling with any fan speed.
Amana's new air sampling system works to maintain set
temperaturewithin
1.5°Fwhile in ENERGY SAVER mode.
Approximately
every 5 minutes the fan will turn on and
"sample" the room airto determine if cooling is needed. If
the room is cool enough, the fan will cycle off. If the room
needs further cooling, the compressor will start along with
the fan until the set temperature is reached.
EN E RGY SAVER has a soft start fan feature. This feature
starts the fan in low speed to reduce noise.
FAN ONLY - FAN ONLY circulates room air
at the set fan speed without cooling.
This
feature can be turned off by pressing the FAN
ONLY, the SMART COOL, orthe ENERGY SAVER button.
Indoor temperature is displayed in FAN ONLY mode.
Unit Control
Control
Panel
OFF - Completely shuts off the unit.
SMART COOL-
SMART COOL adjusts the
fan speed of the unit to achieve the selected
temperature.
The SMART COOL feature
uses computer logic to cool the room quickly
and quietly. The fan speed starts on high, automatically
switches to medium, and finally goes to low as the room
temperature nears the set temperature.
___
LOW FAN, MED FAN, HIGH FAN
- These three buttons are used to
select either a low, medium or
high fan speed to cool. If FAN ONLY is selected these
buttons change fan speed without cooling. Selecting the
fan speed starts normal cooling.
_-_ SET _
SET Temperature
- These key pads
_d;enCrease
or decrease the set tempera-
DELAY TIMER - This button provides a
means of delaying the start up or shut down
of the air conditioner from 1 to 24 hours from the present
time. After setting the delay timer, the displayed time will
countdown to unit start or stop. See next page for details.
Advertisement
Table of Contents
