D-Link DWL-2700AP User Manual page 37

Security: The Multi-SSIDs security can be WPA/WPA2-Enterprise or
VLAN Tag Mode: Select Manual or Dynamic. You can input the VID manually, or configure as
VLAN ID: If you are enabling Guest access and configure Internal and Guest networks
Ethernet Without
Priority:
WMM:
Key Type:
Key Size:
When Primary SSID is set to any of the
following security levels:
None
Open System (WEP)
Shared Key (WEP)
WPA-Personal
WPA2-Personal
WPA-Auto-Personal
WPA-Enterprise
WPA2-Enterprise
WPA-Auto-Enterprise
802.1x
D-Link DWL-2700AP User Manual
WPA-Auto-Enterprise only when the Primary SSID's security is at the same
security level. Also. They must also connect to the same RADIUS server.
dynamic, station can get specific VLAN Tag from RADIUS server to work with
VLAN supported switches or other devices when the Primary SSID's security
is set to WPA-Enterprise, WPA2-Enterprise, WPA-Auto-Enterprise.
on the VLAN, this field will also be enabled.
Provide a number between 1 and 4094 for the Internal VLAN.
This will cause the access point to send DHCP requests with the VLAN tag.
The switch and the DHCP server must support VLAN IEEE802.1Q frames.
The access point must be able to reach the DHCP server.
Check with the Administrator in regards to VLAN and DHCP
configurations.
You can enable this function to untag the packets from wireless to Ethernet
Tag:
if VLAN is enabled.
Specific the 0-7 priority queue when priority is enabled
Select Enable or Disable .
Select Hex or ASCII.
Select from 64-Bits, 128-Bits, and 152-Bits.
Key:
Select from the 1st to 4th key to be set as the active key
Multi-SSID can use any of these security
levels:
None
Open System (WEP)
Shared Key (WEP)
WPA-Personal
WPA2-Personal
WPA-Auto-Personal
None
Open System (WEP)
Shared Key (WEP)
WPA-Personal
WPA2-Personal
WPA-Auto-Personal
WPA-Enterprise
WPA2-Enterprise
WPA-Auto-Enterprise
37