Contacting Customer Support; Inspecting The Optics; Gauging The Movement Of The Telescope - Meade LX200-ACF Instruction Manual

Fig. 34: R.A. Lock.
Fig. 35: Dec Lock.
i. As a final check of alignment, examine the star image in focus with the higher
power eyepiece as suggested (h), under good viewing conditions. The star point
should appear as a small central dot (commonly referred to as an "Airy disc") with
a diffraction ring surrounding it. To give a final precision collimation, make
extremely slight adjustments of the three set screws, if necessary, to center
the Airy disc in the diffraction ring. You now have the best alignment of the optics
possible with this telescope.

Inspecting the Optics

A Note about the "Flashlight Test": If a flashlight or other high-intensity light source
is pointed down the main telescope tube, the view (depending upon the observer's
line of sight and the angle of the light) may reveal what appear to be scratches, dark
or bright spots, or just generally uneven coatings, giving the appearance of poor
quality optics. These effects are only seen when a high intensity light is transmitted
through lenses or reflected off the mirrors, and can be seen on any high quality optical
system, including giant research telescopes.
The optical quality of a telescope cannot be judged by the "flashlight test;" the true test
of optical quality can only be conducted through careful star testing.

Gauging the Movement of the Telescope

A common complaint of many first-time motorized telescope owners is that they
cannot see the telescope "move" when the motor drive is engaged. If fact, when the
batteries are installed, the power is on and the R.A. lock (Fig. 34) engaged, the
telescope is moving. However, the movement is at the same speed as the hour hand
of a 24-hour clock; as such, the movement is difficult to discern visually.
To check the movement of your telescope, look at an astronomical object through the
telescope's eyepiece with the telescope aligned and with the motor drive on. If the
object remains stationary in the field of view, your telescope is operating properly. If
not, check to ensure that you have engaged the R.A. lock and that the power switch
on the control panel is on.
Meade Consumer Solutions Service
If you have a question concerning your
Consumer Solutions Department at:
Telephone: (800) 626-3233
Customer Service hours are 7:00 AM to 5:00 PM, Pacific Time, Monday through
Friday. In the unlikely event that your
write or call the Meade Consumer Solutions Department first, before returning the
telescope to the factory, giving full particulars as to the nature of the problem, as well
as your name, address, and daytime telephone number. The great majority of
servicing issues can be resolved by telephone, avoiding return of the telescope to the
f a c t o r y. If factory service is required, you will be assigned a Return Goods
Authorization (RGA) number prior to return.
What is Smart Drive?
Smart Drive is a feature that allows you to train almost all of the periodic error from
the R.A. and Dec. motor drive worm gears. Periodic error is brought about by tiny
gear imperfections. These imperfections exist in all manufactured worm gears.
These imperfections tend to ever so slightly speed up or slow down the drive
tracking speed during each rotation of the worm gear. This inconsistency in the
tracking rate can have a negative effect on astrophotography. Smart drive lets you
train your telescope system to compensate for these inconsistencies and, as a
result, perform more accurate tracking during astrophotography. Smart Drive
remembers the training even after the telescope is turned off.
If you'd like to learn more about about Periodic Error Correction, see page 40.
, contact the Meade Instruments
LX200-ACF
requires factory servicing or repairs,
LX200-ACF
LX200-ACF TIPS
- 49 -