Electronic Programmer - Blanco OE758GG Instructions For The Use And Care And Installation

INSTRUCTIONS FOR USE
COMPONENT OPERATION

ELECTRONIC PROGRAMMER

Setting the current time
When the electricity has been connected, "12:00"
and the symbol
touching any of the controls (+, - or SELECT),
the symbol MAN appears, and it is possible to
adjust the time within 5 seconds by pressing - or
+.
The time can be adjusted subsequently by
repeatedly touching SELECT until the symbol
flashes and then adjusting the time as
described above.
General notes
− If the current time is adjusted whilst an automatic programme is active, this will be
cancelled.
− It is possible to modify the intensity of the buzzer by repeatedly touching SELECT until
the tone set appears (L1, L2 or L3) and pressing + or -.
− If not deactivated the buzzer stops automatically after about 7 minutes.
− The maximum time of programming is 23 hours 59 minutes.
− If there is a power cut, all the programmed settings are cancelled; when the power
returns, the display pulses showing 12:00. To restore the functioning mode of the
appliance, set the current time again and any programme.
Buzzing timer
To use it as a simple timer, touch SELECT repeatedly until the symbol
desired time pressing + or -, after about 5 seconds the
time starts to decrease; to change the time set or zero it, press + or -.
When the time has run out, to deactivate the buzzer, touch any of the controls.
The maximum time that can be set is 99 minutes.
Setting end of cooking
To start cooking immediately and set the cooking duration:
− put the dishes to be cooked in the oven and select the function and temperature
desired through the function selector and the temperature selector.
− touch SELECT repeatedly until the symbol
5 seconds, pressing + or -.
After a few seconds, the current time will reappear and the symbols
remain activated.
The remaining cooking time can be checked by pressing SELECT until the symbol
selected, or modified or zeroed by pressing + or -.
flash on the display. By
SELECT
symbol stops flashing and the
flashes and set the cooking time within
flashes, set the
and AUTO will
is
13