Disabling Ports On The Qlogic Switch; Figure 9 Storage Connection Diagram; Figure 10 Port Status Online - IBM 8832 Deployment Manual

2.4.2 Disabling ports on the QLogic switch

Here are the steps necessary to disable ports on the QLogic switch. This can be done either via a telnet
session or a browser session.
2.4.2.1 Using Telnet
1. Start a telnet session with the IP address of the QLogic Switch Module.
2. After logging in, enter the command "show port" to view the current status of the ports.
Admin
Port State
---- -----
Ext1:0 Online
Ext2:15 Online
Bay1 Online
Bay2 Online
Bay3 Online
Bay4 Online
Bay5 Online
Bay6 Online
Bay7 Online
Bay8 Online
Bay9 Online
Bay10 Online
Bay11 Online
Bay12 Online
Bay13 Online
Bay14 Online
Figure 9 Port Status Online
Version 3.0, 3/10/2006
The BladeCenter Deployment Guide is intended as a personal productivity tool. It is not intended to be comprehensive and is provided for
guidance only, on an 'as is basis' without warranty of any kind. Please be aware that its contents have not been certified by IBM.
IBM BladeCenter Deployment Guide
Figure 8 Storage Connection Diagram
Operational Login
State Status
----------- ------
Online LoggedIn
Offline NotLoggedIn GL
Online LoggedIn
Offline NotLoggedIn F
Offline NotLoggedIn F
Online LoggedIn
Offline NotLoggedIn F
Offline NotLoggedIn F
Offline NotLoggedIn F
Offline NotLoggedIn F
Offline NotLoggedIn F
Offline NotLoggedIn F
Offline NotLoggedIn F
Offline NotLoggedIn F
Offline NotLoggedIn F
Offline NotLoggedIn F
http://w3-03.ibm.com/support/techdocs/atsmastr.nsf/WebIndex/WP100564
Config Running Link
Type Type State
------ ------- -----
GL F Active
Unknown Inactive Auto
F F Active
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
F F Active
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
Unknown Inactive 2Gb/s
Link
Speed
-----
1Gb/s
2Gb/s
2Gb/s
13