Password Setting; Remote Management - Belkin BoB User Manual

Chapter 5 :
Note:
If your password is lost,
or you cannot gain
access to the user
interface, press the
reset button (colored
blue) on the rear panel
(holding it down for
at least 20 seconds)
to restore the factory
defaults (by default the
password is 'admin') .
Advanced Setup
BoB Advanced Setup Method
TM
Password Settings
Use this page to restrict access based on a password.By default, the password is 'admin' .
Passwords can contain from 3 to 12 alphanumeric characters which are case sensitive.
Enter a maximum Idle Time Out (in minutes) to define a maximum period of time an inactive login session will be
maintained. If the connection is inactive for longer than the maximum idle time, it will be logged out, and you
will have to login to the web management system again (Default: 10 minutes).

Remote Management

By default, management access is only available to users on your local network. However, you can also manage
the router from outside your network via remote management by checking the Enabled check box. You can
set a HOST ADDRESS, which will only allow that computer to use remote management. The port field should be
left as the default setting of 8080 unless you need to change it. After any changes are made you must click on
'Save Settings' to apply them.
Page 12