Listening To Fm/Am Radio; Setting The Frequency Steps; Selecting A Frequency For Reception - Yamaha RX-V479 Owner's Manual

ZONE A ZONE A ZONE B ZONE B
SLEEP SLEEP
S C E N E S C E N E
BD BD
TV TV NET NET
RADIO RADIO
DVD DVD
STRAIGHT STRAIGHT DIRECT DIRECT ENHANCER ENHANCER BASS BASS
PROGRAM PROGRAM
FM/AM
FM/AM
USB USB
INPUT INPUT
VOLUME VOLUME
NET NET
BLUETOOTH BLUETOOTH
MUTE MUTE
SETUP SETUP P OPTION OPTION
ENTER ENTER
RETURN RETURN DISPLAY A A DISPLAY
TOP MENU TOP MENU HOME HOME POP-UP/MENU POP-UP/MENU
RED RED BLUE BLUE
GREEN GREEN YELLOW YELLOW L L
TUNING
MEMORY MEMORY
TUNING TUNING
PRESET PRESET

Listening to FM/AM radio

You can tune into a radio station by specifying its frequency or
selecting from registered radio stations.
• The radio frequencies differ depending on the country or region where the unit is
being used. The explanation of this section uses a display with frequencies used
in U.K. and Europe models.
• If you cannot obtain good reception on the radio, adjust the direction of the FM/AM
antennas.

Setting the frequency steps

(Asia, Taiwan and General models only)
At the factory, the frequency step setting is set to 50 kHz for FM and
9 kHz for AM. Depending on your country or region, set the
frequency steps to 100 kHz for FM and 10 kHz for AM.
1
Set the unit to standby mode.
2
When holding down STRAIGHT on the front panel,
press z (power).
z (power)
PROGRAM STRAIGHT
3
Press PROGRAM repeatedly to select "TU".
CHARGE ENHANCER STEREO TUNED SLEEP
OUT
ECO
TU••••FM50/AM9
4
Press STRAIGHT to select "FM100/AM10".
5
Press z (power) to set the unit to standby mode
and turn it on again.

Selecting a frequency for reception

1
2
MUTE
VOL.
ADAPTIVE DRC VIRTUAL
49
En
Press FM/AM to select a band.
"TUNER" is selected as the input source and then the
frequency currently selected is displayed.
CHARGE ENHANCER STEREO TUNED SLEEP MUTE
OUT
VOL.
ECO
FM 87.50MHz
Press TUNING repeatedly to set a frequency.
Hold down the key for about a second to search stations
automatically.
CHARGE ENHANCER STEREO TUNED SLEEP MUTE
OUT
VOL.
ECO
FM 98.50MHz
"TUNED" lights up when a signal is received from a radio
station.
"STEREO" also lights up when a stereo signal is received.
• You can switch between "Stereo" (stereo) and "Mono" (monaural) for FM
radio reception by selecting "FM Mode" (p.72) in the "Option" menu. When
the signal reception for an FM radio station is unstable, switching to
monaural may improve it.
• You can watch videos input from external devices while listening to radio by
selecting the video input jack in "Video Out" (p.75) in the "Option" menu.
ADAPTIVE DRC VIRTUAL
ADAPTIVE DRC VIRTUAL