Fm/Am Radio - Yamaha RX-V479 Owner's Manual

Problem
No image (contents required the HDCP 2.2
-compatible HDMI device) from the playback
device connected to the unit with HDMI.
The menu of the unit is not displayed on the TV.

FM/AM radio

Problem
FM radio reception is weak or noisy.
AM radio reception is weak or noisy.
Radio stations cannot be selected automatically.
AM radio stations cannot be registered as
presets.
Cause
The TV (HDMI input jack) does not support HDCP 2.2, or the
playback device is connected to other than the HDMI 6 jack. (The
Warning message can be displayed on the TV screen.)
The TV is not connected to the unit via HDMI.
Another input source is selected on the TV.
Cause
There is multi-path interference.
Your area is too far from the FM station transmitter.
The noises may be caused by fluorescent lamps, motors,
thermostats, or other electrical equipment.
Your area is too far from the FM station transmitter.
The AM radio signal is weak.
Auto Preset has been used.
Remedy
Connect the unit to the TV (HDMI input jack) that supports HDCP 2.2. Use the
HDMI 6 jack to connect the playback device.
You can display the menu of the unit on the TV only when they are connected with
an HDMI cable. If necessary, use an HDMI cable to connect them (p.19 to 21).
Switch the TV input to display the video from the unit (HDMI OUT jack).
Remedy
Adjust the FM antenna height or orientation, or place it in a different location.
To select monaural FM radio reception "FM Mode" in the "Option" menu to "Mono"
(p.49).
Use an outdoor FM antenna.
It is difficult to completely eliminate noise. It may be reduced by using an outdoor
AM antenna.
Select the station manually (p.49).
Use an outdoor antenna. We recommend using a sensitive multi-element
antenna.
Adjust the AM antenna orientation.
Select the station manually (p.49).
Use an outdoor AM antenna.
Auto Preset is for registering FM radio stations only. Register AM radio stations
manually (p.50).
106
En