Sound Volume; Changing Channels - Sharp LC-13SH6U Operation Manual

Basic Operation (Continued)

Sound Volume

To adjust the volume
Press VOL (+) to increase the sound volume.
The bar indicator shifts right.
VOLUME
50
Press VOL (–) to decrease the sound volume.
The bar indicator shifts left.
VOLUME
10
To mute the sound
Press MUTE to temporarily turn off the sound.
The MUTE mark is displayed for 4 seconds.
Press MUTE or VOL (+)/(–) to turn the sound back to the
previous level.
The mute function is automatically turned off when any of
the following buttons are pressed: POWER, MUTE, VOL
(+)/(–) or MTS.
VOLUME
10
A
• When VOL (+)/(–) is pressed in the Mute mode, the sound turns
on and the volume indicator is displayed.
• The Mute function is canceled when POWER is pressed.
To select MTS (Multichannel TV Sound)
1
Press MTS to display the MTS screen.
2
Press MTS to select the MTS settings.
STEREO: stereo audio
SAP: secondary audio program
MONO: monophonic audio
<
STEREO ON A I R
<
SAP ON A I R
MONO
A
• "ON AIR" appears when a STEREO or SAP broadcast is being
aired.
ＬＣ－１３／１５／２０ＳＨ６Ｕ＿Ｅ＿Ｐ１１－１８．ｐ６５

Changing Channels

You can select channels using Channel Select or
CH ( )/( ).
• This LCD TV set allows you to select up to 125 channels
(1 to 125). To select a channel, enter a 2- or 3-digit number.
Using Channel Select
When selecting the channel using Channel Select, complete
input of the channel number by holding down the button for
the last digit for a moment.
To select a 1- or 2-digit channel number (e.g., Channel 5):
Complete the following procedure within 4 seconds.
1
Press the
A
• When selecting a 1-digit channel number, do not fail to press the
button first.
To select a 3-digit channel number (e.g., Channel 115):
Complete the following procedure within 4 seconds.
1
Press the
3
Press the
A
• The 3-digit channel number can be selected only when the
receiving mode is set to CABLE in CH-SETTING.
Changing channels with CH (
Air: Press CH ( ) and the channels change in the order shown below:
2 → 3 → . . . → 68 → 69 → 2 → 3 → . . .
Press CH ( ) and the channels change in the order shown below:
3 → 2 → 69 → 68 → . . . → 3 → 2 → . . .
Cable: Press CH ( ) and the channels change in the order shown below:
1 → 2 → 3 → . . . → 125 →1 → 2 → 3 → . . .
Press CH ( ) and the channels change in the order shown below:
3 → 2 → 1 → 125 → . . . → 3 → 2 → 1 → . . .
Using FLASHBACK
Press FLASHBACK to switch the currently tuned channel
to the previously tuned channel.
Press FLASHBACK again to switch back to the currently
tuned channel.
13
2
button. Press the button.
0 –
5
2
button. Press the button.
1 – – 1 1 –
button.
1 1 5
)/( ) on the remote control
2006.02.15, 16:06