D-Link DIR-514 User Manual page 30

Section 3 - Configuration
WPS: Select whether you would like to enable or disable WPS features.
AP PIN (also If you use Windows 7's Connect to a network wizard to do initial
known as WPS configuration of the router, you will need to enter the WPS PIN/AP
PIN): PIN into the wizard when prompted. The factory default WPS PIN/
AP PIN is printed on a label located on the bottom of the router. You
can click the Generate New PIN button to change it to a randomly
generated PIN.
Config Mode: Select whether the WPS config mode should be set to Registrar or
Enrollee. In most cases, this should be set to Registrar so that you
can use WPS to connect new wireless clients.
Config Status: If this is set to CONFIGURED, the router will be marked as "already
configured" to computers that try to use WPS configuration, such as
Windows 7's Connect to a network wizard. You can click the Release
button to change the status to UNCONFIGURED to allow for WPS
configuration of the router.
If this is set to UNCONFIGURED, you can click the Set button to
change the status to CONFIGURED to block WPS configuration of
the router.
Config Method: This lets you choose whether to use the Push Button connection
method (PBC) or PIN method to connect to a wireless client when
the Trigger button is clicked. If you choose the PIN method, you will
need to enter a 8-digit PIN number that the wireless client need to
use to connect to your router.
WPS Status:
This will show the current WPS connection process status. Click the
Trigger button to initiate a WPS connection.
D-Link DIR-514 User Manual 26