Fail Safe Function 失控保護功能 - THUNDER TIGER Jackal 6544-F Instruction Manual & Parts Catalogue

7
FAIL SAFE FUNCTION 失控保護功能
FAIL SAFE FUNCTION
1. Function
Failsafe aims to prevent out-of-control driving of RC Car or RC Boat. If the Receiver is not able to
receive Any signal, from the control to Throttle, the parameter of Throttle on Receiver will turn back to
its original Setting.
2. Setting
a. Turn on the Transmitter switch;
b. Turn on the Receiver switch, the LED will be lighting;
c. Adjust Transmitter's Throttle, make the car/boat to stop or flameout, then keep still.
d. Press the "setting" button on Receiver (as the pic below), the LEDwill be flashing, then stop after
3seconds around, which means setting finished.
e. OK!
3. Testing
f. Turn on the Transmitter switch;
g. Turn on the Receiver switch;
h. Turn off the Transmitter switch;
i. Servo of Throttle will turn back to its original setting automatically;
j. Setting is successful if above procedures finished completely.
失控保護功能說明
1. 功能說明
失控保護功能是對模型車或船進行失控保護，避免因失控造成損失。主要是對油門通道進行控制，當接
收機接收不到控制信號時，接收機的油門通道將自運行到當初設定的值，以免誤動作。
2. 設定方法
a. 將發射機開通電源進入工作狀態.
b. 將接收機接通電源進入工作狀態，此時信號燈恒亮.
c. 控制發射機的油門通道，使油門控制伺服器或調速器進入剎車或熄火狀態，然後保持不動.
d. 此時將接收機的設定鍵（如圖按下），此時接收機LED信號燈會閃爍，並在3秒左右停止.
e. 設定完成.
3. 測試
f. 將發射機打開進入工作狀態.
g. 將接收機接通電源進入工作狀態.
h. 將發射機關閉電源.
i. 此時可看到油門通道的伺服器便會自動進入設定狀態的位置
j. 以上動作如果可以完成表示設定OK
按
7