Battery Installation 電池安裝 - THUNDER TIGER Jackal 6544-F Instruction Manual & Parts Catalogue

4
BATTERY INSTALLATION 電池安裝
a
c
e
a. Install 4pcs alkaline or rechargeable AA-size batteries into transmitter.
b. Make sure switch is OFF.
c. Release both velcro bundling strap.
d. Put battery into battery box.
e. Tight battery with velcro bundling strap to fix battery.
f. Connect battery cable with ESC cable.
(***Please always disconnect battery cable from ESC after use, and take out battery from battery box***)
Disconnect Batteries After Use
Always disconnect the batteries from the speed control when you are finished using your
vehicle. The switch on the speed control only shuts off power to the receiver and servos.
The speed control continues to draw power as long as it is plugged in and may
overdischarge your batteries if they are left connected to the speed control.
a. 安裝四顆三號鹼性電池或充電電池於發射機內。
b. 先確認電源是關閉的。
c. 鬆開前後束帶。
d. 安裝適當電池於電池盒中，電池出線面向電池盒的前面。
e. 放入電池後，將束帶穿過方環向上拉緊，再往回貼合（本束帶為勾毛同體）。
f. 將電池線連接速控器電源線。
操作完畢注意事項
請務必於每次操作完畢後解除電子速控器與電池的連結狀態。電子速控器電源開關僅只關掉接收機與伺服
機的電源供應。電池內部電流消耗會因為電源線未拔離而持續且可能會因此而過度放電而導致無法預期的
危險。
(注意：每次操作完畢，請將電池與速控器電源線分離並取出電池。)
4
(Batteries are not included in the kit. 本產品不含電池)
b
d
f