Figure 3-24 Attaching the side plate
Number in
figure
1
2
11. Attach the front and rear doors of expansion racks 1 and 2.
The work of connecting the racks ends when the front and rear doors are attached.
3.4
Mounting the Chassis in a Rack
This section describes the procedures for mounting the chassis in an equipment rack.
The method of securing the rails differs depending on the rack type. As described in
this section, the methods of securing them differ between the racks with supporting
columns having angled holes and the racks with supporting columns having M6
screw holes.
For rack details, see the manual for the rack used.
If the chassis has already been mounted in the rack, go to
Components."
For the rack mounting procedure of each chassis, see the following sections:
Mounting the SPARC M10-1 in a rack
■
Mounting the SPARC M10-4/SPARC M10-4S in a rack
■
Mounting the PCI expansion unit in a rack
■
FRONT
Description
Side plate
Screw
"3.5 Mounting Optional
Chapter 3 Installing the System
95