Removing The Control Board; Removing The Control Board's Rear Cover; Removing The Interface Board; Removing The Selector Knob - Electrolux 6000 Service Manual

3. Disconnect the wiring from the control board and lift
the console off.

Removing the control board:

1. Disconnect the dryer from electrical supply and
remove the top panel.
2. Remove the console.
3. Remove the (5) screws holding the control board to
the console and lift to control off.

Removing the control board's rear cover:

1. Disconnect dryer from the electrical supply and
remove the control board.
2. Release the two locking tabs and roll the cover off of
the control.

Removing the interface board:

1. Disconnect dryer from the electrical supply and
remove the control board.
2. With the control board removed, the interface board
will lift out.

Removing the selector knob:

1. Disconnect dryer from the electrical supply and
remove the control board.
2. Using a pair of needle-nose pliers, squeeze the shaft
of the selector knob and pull it out the front.
66