Panasonic WV-SW390 Series Operating Instructions Manual page 13

–
when there are many moving objects other than the subject
–
when there is a change to the axis of the camera's lens
–
when the subject moves directly underneath the camera
–
when there is harsh flickering
–
when there are reflections from light entering the dome due to reflections from a window
or road, or from a backlight
–
when the target is hidden behind a utility pole or other objects
–
when the subject passes by other moving objects
–
when the target moves too fast or too slow
–
when the camera is shaking
•
When the zoom ratio is set to the "Tele" side, it may be difficult to obtain accuracy with the auto
tracking function. It is recommended to use the auto tracking function with setting the zoom
ratio to the "Wide" side.
•
Auto pan: Automatically pans between the start position and the end position set in advance
(®page 111).
Even when the camera is operated for zooming or focusing, the camera continues panning.
(However, panning will stop when the zoom button (x1) is clicked.)
•
Preset sequence: Automatically moves to the preset positions (®page 108) orderly (start from the
lowest preset position number).
•
360 map-shot: Moves 45° horizontally at a time and repeats 8 times to shoot images of each 45°
position (45° x 8 = 360°), and then displays 8 thumbnail images of each 45° position (45° x 8 = 360°)
on a newly opened window. When a thumbnail image is clicked, the camera moves to the respective
position and live images will be displayed on the "Live" page.
•
Preset map-shot: Eight thumbnail images of the preset position 1-8 (®page 108) will be displayed
orderly on a newly displayed window. When a thumbnail image is clicked, the camera moves to the
respective position and live images will be displayed on the "Live" page.
Note
•
Do not operate the browser until all the thumbnail images are displayed and the camera returns to
the original position (where the camera was when "360 map-shot" or "Preset map-shot" was carried
out).
•
When "360 map-shot" is carried out while the camera is moving (panning/tilting), images captured
while panning/tilting may be displayed as the thumbnail display. In this case, stop the current
operation and carry out "360 map-shot" again.
•
When "Preset map-shot" is carried out with an unregistered preset position (among preset position
1-8), the thumbnail image of the preset position before the unregistered preset position will be
displayed.
In this case, the camera will not move when the thumbnail image is clicked.
•
The camera will not always return to the exactly same position where it was before "360
map-shot" or "Preset map-shot" was carried out. (It may sometimes be slightly different.)
•
The window on which the thumbnail images are displayed will close when clicking the following
buttons that can switch the camera channel or reload images: [Live], [Multi-screen], [H.264],
[MPEG-4], [JPEG], [Stream], [Image capture size], [Image quality], [Setup].
To display the thumbnail images again, carry out "360 map-shot" or "Preset map-shot" again.
•
Patrol 1-4
SW396
: Performs patrols 1-4 that were set in advance. (®page 113)
SC386
1 Monitor images on a PC
Operating Instructions 13