Delivery And Dealer Service - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Pre-delivery service
1. Top up battery with acid and recharge for four hours.
2. Fit steering wheel, seat and any optional equipment.
3. Fit cutting unit.
4. Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit should be
12–15 kg, or set to maximum lift if brush is to be fitted).
Adjust cutting unit so that rear edge is about 2–4 mm higher than front edge.
Adjust cutting unit height setting so that cutting height limit is 5 mm above the frame of the unit at the
lowest cutting height.
5. Check that the right amount of oil is in the transmission.
6. Check and adjust tyre pressure (60 kPa, 0.6 bar).
7. Connect battery.
8. Fill with fuel and start engine.
9. Check that machine does not move in neutral.
10. Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lift lever safety switch.
Safety switch for hydrostatic transmission pedals.
11. Check engine revs 3 000 75 rpm.
12. Tell customer about:
Need and benefits of following the service schedule.
Need and benefits of having machine serviced every 300 hours.
Service and the effect of the service journal on the machine's second-hand value.
Range of applications for BioClip.
13. Complete proof of sale, etc.
After first 8 hours
1. Change engine oil.
6
– Svenska

Delivery and dealer service

www.mymowerparts.com