Making Dough; Baking Cake - Panasonic SD-B2510 Operating Instructions And Recipes

Making Dough

1 4
See P. EN10 of Preparations
-
Press or button in the Menu (
5
select a dough menu.
Press button to start.
6
● Display shows the remaining time until the program is
complete.
When dough is ready )machine beeps 8 times and
7
the cube ) ( near END flashes(, press
and unplug.
Tips: Timer is not available on dough menus except Pizza.

Baking Cake

1 4
- See P. EN10 of Preparations
Select the menu 18
5
Press button to start.
6
● Display shows the remaining time until the beep sounds.
After about 12 minutes, open the lid when you
7
hear the beep sound. Scrape off the flour within 5
minutes while is flashing. Close the lid and
restart.
● Kneading will continue after 5 minutes without press
Press button and remove cake when machine
8
beeps 8 times and the cube ) ( near END flashes.
Bread Dough
Shape the finished dough to your favourite shape
8
) bar to
and allow it to rise until double size, then bake in
the oven.
Pizza Dough
Divide the dough with scraper and shape them
8
into balls.
button
Cover them with damp kitchen towel and leave it
9
for 10 minutes.
Shape into a flat round and make holes with a
10
fork.
Spread your favourite sauce and desired topping
11
then bake it in the oven.
Additional Baking
● If baking is not complete, follow the following method. )Additional
baking time can be made up to twice within 20 minutes while the
machine is still hot. The timer will start again from 1 minute by
pressing the
①
Select the menu )Skip it if you have not pressed
②
Set the baking time
It can be set to 1 - 20 minutes.
●
③
Press button to start.
To discontinue baking, hold
●
Tips:
● Timer is not available on this menu. It only sets the duration of the
baking time.
● Use a rubber spatula to avoid damaging the bread pan. Do not use
metal spatula.
button.
● If you shake hard to remove cake from the bread pan, it will lose
shape.
button as required.(
button.
Turn to P. EN16 -
EN17 for recipes
Turn to P. EN17 for
recipes
button in step 8(
EN13