Memory Channel Lockout - Kenwood TM-732A Instruction Manual

The factory default is the Time Operated Scan mode.
To switch between the modes use the following
procedure.
@Hold/Resume selection
1. Press the BAND SEL key to select the desired band.
2. Press the F key for longer than 1 second. The F
indicator will flash.
3. While the indicator is flashing press the VFO key.
This will switch the Hold / Resume mode to the
Carrier Operated mode and the CO indicator will
light.
To return to Time Operated mode repeat steps 1, 2
and 3.
7. Memory Channel Lockout
This function allows you to specify which memory
channels you wish to skip during memory channel
scan.
1. Press the BAND SEL key to select the desired band.
2. Press the MR key to select the memory channel
mode.
3. Select the memory channel that you wish to skip by
turning the Tuning control or pressing the
microphone UP/DWN keys.
4. Press the F key for longer than 1 second. The F
indicator will begin to flash. Within 10 seconds of
pressing the F key press the MR key. A * indicator
will appear to the left of the memory channel
number. This indicates the memory channel will be
skipped during the memory channel scan.
5020
5. Repeat steps 2, 3 and 4 to lock out any other
channels you wish to skip.
6. To cancel the lockout, select the desired memory
channel as described in steps 1, 2,3 and 4 above.
A * indicator should appear to the left of the
memory channel number. Press the F key for longer
than 1 second and then press the MR key. The *
indicator should turn off.
43