Kenwood TH-77A Instruction Manual page 52

RECHARGING TIME ( Hours)
MODEL PB-5 | PB-6 | PB-7 | PB-8 | PB-9 | PB-10
Hight (mm) | 36.5 | 555 | 985 | 84 | 985 | 555
Weight(g) | 80 | 165 | 290 | 250 | 250 | 160
DC-5 NA 15 30 NA 15 NA
BC-10 8 8 15 8 8 15
BC-11 1 i i i 1 NA
BC-9 NA 15 30 | NA NA NA
125
NOTE ;
INSTALLING THE CTCSS UNIT TSU-7
BE SURE TO TURN THE POWER SWITCH OFF
BEFORE REMOVING THE BATTERY CASE.
1.
52
Attach the cushion supplied with the TSU-7 to the
rear of the unit. Remove the backing from the other
side of the cushion.
Remove the rubber cap on the DC IN, MIC, and
SP sockets.
Remove the Battery Pack and remove the four
philips head screws from the terminal plate of the
transceiver. (Fig.1)
Remove the three screws holding the front and rear
of the case together. (Fig.2)
Slightly lift the sides of the battery case at the front
and rear, as shown in figure 3.
Lift up PC board A , and disconnect PC board B from
it. (Fig.1)
Connect the TSU-7 to PC board A in place of PC
board B.
When putting the case back together, make sure
the PTT switch base ( part C ) fits in the groove (
part D ) in figure 3.
Secure the front and rear of the case with the
screws.
. Fit the end of the terminal plate into the release
button hole and tighten the screws (Fig. 4).
PC Board(A)
S
eeecll
release button hole J)
Fig 4.