Kenwood TH-77A Instruction Manual page 45

4-9-4. Paging Reception (Wait)
1. Tune to the predetermined frequency.
2. Press the F key, then press the 6/M.DT key (5/S.DT key
for a subband) once or twice to enter the paging
mode.
P indicates paging .
If the distant (receiving) station has activated a battery saver circuit
it might not receive the PAGING code. There are two recommended
methods of compensating for this situation.
1. Press the PTT switch for a few seconds, send the PAGING code,
release the PTT switch, then press the PTT switch again and resend
the appropriate code.
Proper PAGING operation will occur if you ensure the battery saver
circuit is disabled whenever you intend to operate using either the
PAGING modes.
N
Stand by with individual code
ad When called with your station ID code, the memory
number automatically change to 0. The ID code of
the calling station is displayed. (For KENWOOD's
transceivers. This also applies to the following
descriptions.) (Example: Frequency: 145.660 Mhbz,
calling station code: 444)
P flashes.
Zero is displayed to indicate that your station is
being called.
4. The squelch is opened and the calling other party is
heard. (The individual code of the calling station is
stored in memory 0.)
5. Press the PTT switch to respond to the calling
station. 145.660MHz
111* 444
ae i
After the remote station has been called, cancel paging.
Communication can be performed more efficiently.
(3x : If the remote station code can not be recognized, E
appears on the display panel. )
ERROR
indicato icator 700
eee]
APO
These codes are the previous ones.
45