Catalogue Of Errors - Bosch CL400 Manual

7.3.3

Catalogue of Errors

Error Information [hex]
Reaction Class
00 00
Error during command execution on one's own AST module
Error Information [hex]
Reaction Class
01 30
01 30
03 30
01 30
01 30
03 30
03 30
03 30
03 30
01 30 E0 to FF
01 33
03 33
03 33
03 33
03 33
03 33
03 33
03 33
03 33
03 33
03 33
01 34
01 34
03 34
01 34
1070 072 196-101 (00.06) GB
General Information Regarding BUEP-E and BUEP19E
The PW column contains the parameter which has probably caused the
error.
Explanation
Code PW
00 Error-free job
Explanation
Code PW
21 RUN error. The module is in the RUN state. The specified command
cannot be executed, AST
22 Change of operating mode not possible, AST
23 4, 5 AST field access not permitted; the desired access (read/write/bit) is not
applicable for this field.
24 AST field protection active; at the moment, the desired field is reserved
by another position
25 Timer disabled; actual time values can only be changed when time is
running
26 6 AST module number too large; larger than the allowed maximum value
27 6 AST data module not available, in the application program
28 8, 12 AST data module too small, in the application program
2B Data Error during writing to the system clock
Reserved for system bus error
02 Memory access error
03 4 Wrong memory type; e.g. writing on EPROM memory
10 7 No module exists for the specified AST block address
18 5 Unsupported command code; unequal to D/DB/DF/M
19 4 Type of command neither E nor A
20 5 AST command code undefined
3A 4, 8 Wrong address orientation, e.g. writing a word on odd addresses
3B 8 Invalid address range
3C e.g. 6 Invalid parameter
3D Invalid type of operand
63 Buffer overflow, amount of data too much
05 Server does not respond; Time-out
06 Server not found; no ARP
07 14, 15 No server found for specified IP address
08 No IP address entered on the module
7- -15