Global Commands
26
G8264 Command Reference for ENOS 8.4
Some basic commands are recognized throughout the ISCLI command modes.
These commands are useful for obtaining online help, navigating through the
interface, and for saving configuration changes.
For help on a specific command, type the command, followed by help.
Table 3.
Description of Global Commands
Command
?
list
exit
copy runningconfig
startupconfig
logout
traceroute
Action
Provides more information about a specific
command or lists commands available at the current
level.
Lists the commands available at the current level.
Go up one level in the command mode structure. If
already at the top level, exit from the command line
interface and log out.
Write configuration changes to non‐volatile flash
memory.
Exit from the command line interface and log out.
Use this command to identify the route used for
station‐to‐station connectivity across the network.
The format is as follows:
traceroute [{<hostname>|<IP address>}
[<max‐hops (1‐32)> [<msec‐delay (1‐4294967295)>]]
[dataport|mgtport]]
Where:
hostname/IP address: Sets the hostname or
IP address of the target station.
maxhops: Sets the maximum distance to trace.
msecdelay: Sets the number of milliseconds
to wait for the response.
By default, the management port is used. To use a
specific port, use the following options:
data port: dataport
management port: mgtport
Note: The DNS parameters must be configured if
specifying hostnames.