4How To Restore The Original Factory Settings Of This Product - Panasonic YC-300BZ3YHD Operating Instructions Manual

8.1.4 How to restore the original factory settings of this product
• The following table shows how to restore the original fac-
tory-setting. (Underlined bold character in the "LCD" col-
umn indicates the cursor position.)
• Once the original factory settings are restored, the cur-
rent settings are eliminated unless they are stored in the
memory.
• For any important welding conditions, store them in the
memory (see section "Storing welding conditions".) or
1 Hold down the JOG dial, and while holding it down,
turn on the "POWRE" switch.
2 Press the JOG dial to determine the choice.
* When you turn the JOG dial without pressing down,
the screen displays the next set item. In that case,
turn it further until the desired set item reappears.
3 Press the JOG dial.
4 Turn the JOG dial and have "YES" displayed.
5 Press the JOG dial
6 Turn the JOG dial and have "YES" displayed.
7 Press the JOG dial to complete.
OMCTT5621E18
Operation
write them in the "Welding conditions memorandum" in
Appendix.
Note
If you are confused during the operation, turn the power
off, and redo the operations from item (1) again.
Set-value display
Then indication changes to
Settings
LCD
Rescue Menu
YC-300B Series
1 Set Defaults?
No
1 Set Defaults?
No
(Cursor flashes.)
1 Set Defaults?
No
Are you sure?
* * * *
(Cursor flashes.)
Welding Current
33