Bosch Pack201HS Instruction Manual page 84

Pack201 | Operator Interface | Section 4
Message
INCREASING FILM�
DECREASING FILM
ESTOP BUTTON PRESSED�
SAFETY RELAY OUTPUT�
HIGH PRODUCT STOP�
AUTO WAITING�
STANDBY� WAITING FOR DOWNSTREAM
EQUIPMENT�
LOW AIR STOP�
MACHINE CAN NOT RUN IF NOT IN SYNC�
FILM BROKEN STOP�
RESET SPLICER�
INFEED INCREASING�
INFEED DECREASING�
TEMPERATURE FAULT STOP�
DISCHARGE FOLLOWING ERROR�
LOW FILM ERROR�
UNCUT REJECT�
SPLICE REJECT�
MANUFACTURERS SPLICE REJECT�
OUT OF REGISTRATION REJECT�
MELTED FILM REJECT�
NO GAP / NO SEAL REJECT�
© Bosch Packaging Technology, Inc.
All rights reserved 2012
ADJUST FILM TO GET INTO REGISTRATION
PULL OUT THE ESTOP BUTTON TO ENABLE WRAPPER START BUT-
TON�
CLOSE GUARD DOORS AND PULL OUT ESTOP PB'S TO ENABLE
WRAPPER START�
THE HIGH PRODUCT DETECTION CIRCUIT WAS TRIGGERED�
PRESS START TO RUN�
MACHINE WAITING FOR SIGNAL TO RUN� CAUTION! THE MA-
CHINE MAY START AT ANY TIME!
CHECK DOWNSTREAM EQUIPMENT FOR THE REASON WHY THE
WRAPPER STOPPED� USE CAUTION! THE WRAPPER MAY START
AT ANY TIME�
AIR PRESSURE SENSOR DETECTED LOW AIR� CHECK AIR
INPUT
RETURN TO MANUAL OR AUTO MODE AND PRESS START BUTTON
TO SYNC THE MACHINE�
CHECK THE FILM PATH OR THE PROXIMITY SENSOR� PRESS
START TO RUN�
PRESS THE RESET SPLICER BUTTON ON KEY PAD TO RE-ARM THE
SPLICER�
THE INFEED IS INCREASING TO THE NEW OFFSET�
THE INFEED IS DECREASING TO THE NEW OFFSET�
LOOK AT TEMPERATURE CONTROLLER OR ITS MANUAL
FOR MORE INFORMATION�
CHECK THE FEEDBACK IN E-STOP TO RESET THE FOLLOWING ER-
ROR OR PRESS START BUTTON TO RUN�
FILM MONITORING CIRCUIT DETECTED LOW FILM�
NO GAP DETECTED BETWEEN PACKAGES ON THE DISCHARGE
PACKAGES INVOLVED WERE REJECTED�
A SPLICE WAS PERFORMED AND THE PACKAGES INVOLVED
WERE REJECTED�
A MANUFACTURERS SPLICE WAS DETECTED AND REJECTED�
PACKAGE FOUND TO BE OUTSIDE THE PRESET LIMITS OF REGIS-
TRATION ERROR
PRODUCT HELD OVER FINWHEELS LONGER THAN PRESET TIME
AND WAS REJECTED�
PRODUCT WAS DETECTED WITHIN THE PRESET WINDOW
AND REJECTED�
Action
EN | 53