Bosch Pack201HS Instruction Manual page 28

Pack201 | Operator Instructions | Section 3
Backstand
When changing to a different type or size of film:
1� Remove the outer chuck and the roll of film.
2� Place a new roll of film on the film reel holder.
3� Note the direction of unwinding�
4� If necessary, reposition the centering cone on
the film reel holder.
5� Replace and tighten the outer chuck against the
film roll.
6� Use the centering knob to fine tune the film roll
position�
7� If necessary, reposition the inclination arm and/
or roller for proper film flow.
8� Record settings on the data sheet for future
reference�
When threading the film:
1� Push the balance arm toward the center of the
backstand until it locks into the down position�
2� Thread the film according to the diagram.
3� Pull out on the release rod to release the bal-
ance arm�
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Chuck
Balance Arm
Centering Knob
EN | 12