Bosch Pack201HS Instruction Manual page 80

Pack201 | Operator Interface | Section 4
PARAMETER
Out Of Registration # To Reject (prod)
Out Of Registration Reject Enable
Out Of Registration Reject Shifts (prod)
Package Length (mm)
Pause Offset (deg)
Power Feed Roll Enable
Product Length
Product Offset (Position) (mm)
Product Width (mm)
Products Per Flight
Pulse X Enable
Pulse X Speed Compensation
Rate At 10 Volts
Registration Enable
Registration Offset
Reject Verify Shift (cycles)
Remote Feeder Enable
Remote Speed Inc/Dec
Run Rate (ppm)
Short Product # To Reject
Short Product Reject Enable
Short Product Reject Shifts
Short Sync Cycles
© Bosch Packaging Technology, Inc.
All rights reserved 2012
DEFINITION
This is the desired number of packages to reject when an out of registra-
tion package is detected�
In the ON position the out of registration reject is active� In the OFF
position the reject is disabled�
This is the number of cycles from the out of registration reject eye to the
reject device�
This is the measured distance between two registration marks on the
sealing material�
This is a correction that may be added to change the position of the cut-
ting head pause�
In the ON position the power feed roll motor is active� In the OFF posi-
tion the motor is disabled�
This is the actual measured length of the product to be run�
This is the position of the product in the package� This value can be
adjusted�
This is the actual measured width of the product to be run�
This is the actual number of products to be in each infeed flight.
In the ON position the pulse is active� In the OFF position the pulse is
disabled�
This allows for mechinacal delays at higher speeds to keep the pulse X
"window" in position�
This is the speed that the machine will run with a 10 volt signal from the
feeder�
In the ON position the registration eye is active� In the OFF position the
registration eye is disabled�
(Cut Position) This is the position of the cutoff on a package when running registered
film.
This is the number of cycles from the reject verify eye to the reject de-
vice�
In the ON position the remote feeder option is active� In the OFF posi-
tion the option is disabled�
This function has not yet been developed�
This is the desired wrapper speed in packages per minute when the
machine is in run mode�
This is the desired number of packages to reject when a short product
is detected�
In the ON position the short product reject eye is active� In the OFF
position the reject eye is disabled�
This is the number of cycles from the short product reject eye to the
reject device�
This is the number of cycles the machine will run during the short sync
operation� (Typically the number of packages from the endseal crimpers
to the pusher drop off�)
EN | 49