External Applications; Peak Load Signal; Peak Load Prevention; Com Module Selection - Miele PDR 908 HP Operating And Installation Instructions

Supervisor level

External applications

Peak load signal

External hardware is connected via the
Miele XCI box.
The peak-load negotiation function
enables the tumble dryer to be
connected to an energy management
system. When a signal is registered,
the tumble dryer's heater is switched
off for a short period or the appliance
is prevented from being switched on.
The tumble dryer may only be
operated with a peak-load system if
this system is connected to the tumble
dryer via the Miele XCI Box.
- Factory setting: No function
- Peak load with 230 V
- Peak load with 0 V
- COM module

Peak load prevention

With this function, the application of a
hygiene programme is not amended
when a peak load signal is in place.
The heater stays switched on.
- Factory setting: Off
- On
100

COM module selection

This tumble dryer is equipped with an
integrated Wi-Fi module. However, the
tumble dryer can also be equipped
with an external module.
- Off
- Internal module (factory default)
The internal Wi-Fi module is used.
- External module
An XKM module or RS232 module is
inserted into the module slot.

Availability of Miele digital products

The ability of Miele digital products
depends on the availability of the
services in your country.
The different services are not available
in all countries.
For information about availability,
please visit www.miele.com.