Placing The Hydro Kit Controller - LG MULTI V HYDRO KIT ARNH963K2A4 Installation Manual

Placing the Hydro Kit Controller

Hydro Kits include a factory-supplied controller (with integral temperature sensor), but also can be used with remote temperature sensors
and third-party thermostats (optional; sold separately). If the Hydro Kit's water flow will be controlled by monitoring the conditioned space
temperature, proper Hydro Kit operation depends on the location of the controller (sensor, thermostat). A good location will be to protect
the controller (sensor, thermostat) away from direct sunlight, high
humidity, water vapor, and where it could be directly exposed to cold
air. Controller (sensor, thermostat) must be installed four (4) to five
(5) feet above the floor where its display can be read easily (if regu-
lations of the American Disability Act [ADA] do not require a lower
mounting height), in an area with good air circulation, and where it
can detect an average room temperature.
•
•
•
•
•
1. Pull cable between the controller handy box (if used) and the
Hydro Kit.
2. Store a minimal amount of cable in the handy box.
3. If the cable between the controller (sensor, thermostat) and the Hydro Kit is too long,
cable, tie-wrap it, and leave it next to the Hydro Kit location.
•
•
•
•
•
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.
INSTALLING THE HYDRO KIT
Placing the Hydro Kit Controller
TEMP
Remote Controlle r
NO
TEM P
roller
ot e Cont
Rem
NO
do not cut. Coil any spare communications
YES
TEMP
Remote Controlle r
TEM P
ot e Cont roller
Rem
NO
4 to 5 feet
above the floor
25