PRE-COMMISSIONING
Hydro Kits with Heat Recovery Units
Valve (Port) Detection for Hydro Kits
During the pre-commissioning process, each system component is given a unique address so that the air-source or water-source unit will be
able to distinguish the components from the others. Addresses are assigned either by auto or manual valve (port) detection. For Hydro Kits:
1. The numbers of the connected vapor and liquid pipes must match.
2.
• Use "Mode 1" if the water temperature is greater than 86°F (30°C)
• Use "Mode 2" if water temperature is less than 86°F (30°C)
•
3.
switch failed to close.
manual.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.
100