8.1.2 "CALL" and "RECORD"
Reminder
●"Call" is a function to use stored welding conditions and "Record" is to store the well-tuned
welding conditions.
Record/Call operation is applicable to the set values of current ・ voltage, spot welding time, arc
characteristics, penetration control, welding control, pulse ON/OFF, material, wire diameter, gas
and F. Adj.
■"Record" operation
Reminder
During Record operation, welding can't start. (Gas check works.).
No.
●Select Record in ○
1
the right )
●Select the channel (CH1-CH100) to be used in ○
2
(It alternately shows "CH" and current set value in
○
, channel and voltage set value in ○
2
●After operation finishes, select ○
3
"welding" mode. Till now data recording finishes.
Note During Call operation,○
■"Call " operation
During the selection of Call, welding condition can NOT be changed (gas check
Reminder
and manual wire feeding function work.)
No.
●Select Call in ○
1
right )
●Select channel (CH1-CH100) to be called in ○ 7
2
(It alternately shows "CH" and current set value in
○
, channel and voltage set value in ○
2
●At present, (welding condition is already being
3
called) welding can start.
●After operation finishes, select ○
4
" welding " mode
Settings
Operation
( as shown in the picture on
12
5
and return to
12
○
○
○
○
operation does not function.
13
14
15
16
17
Operation
( as shown in the picture on the
12
5
and return to
12
7-segment LED
.
7
)
7-segment LED
C H
)
25
O F F