Connecting Jig(S); Layout Of Jig Terminals; Functions Of Jig Terminals - Panasonic YD-350GL4 Operating Instructions Manual

6.2 Connecting jig(s)
There are two types of jig terminals (Jig terminals 1 and 2)
1 Jig terminal 1
（ ）
To send out a command for the emergency stop and
temporary stopping from a jig or another device.
To send out the current detection signal to a jig or
another device.
Location: On the chassis inside the product.
2 Jig terminal 2
（ ）
To install an external voltmeter or ammeter.
Location: On the chassis inside the product.
Note
• Keep the communication cables away from the welding
arc area, the welding torch, the base-material-side
cable, etc. to prevent troubles caused by incorporation
of the high frequency wave. And keep the wiring length
within 10m.
• Lead wires from the wiring port. (Make a cut in the
grommet wall to insert wires.)
As to signal wires from another device:
make sure to tie the lead-in wires in a bundle with
a binding band (15 cm) over the boot of the
grommet to prevent dust to get in
6.2.1 Layout of jig terminals
* Connect the start signal of this product to the torch switch receptacle of the wire feeder.
107 106
41
When touching a printed circuit board, observe the following item to prevent
electrostatic destruction of the printed circuit board.
Before starting an operation, for example, touch any metal part of the case with your hand
to discharge static electricity.
107 105 107
53 55 54
Connection
Top view (without top panel)
terminal.
External
terminal block 1
103 102
104
CD CD(+)
(-)
65 55 56
＋15V
19
Wiring port
External terminal
block 2
101
100 81
A
50 51 128
V
80
83