Maintenance 6. Maintenance Parts Replacement Procedures
6.8 Special Board
6.8.1 Replacing the Special Board
Special Board
(1) Turn OFF the Controller and unplug the power connector.
Removal
(2) Disconnect the external cables from the Special Board if they are connected.
(3) Remove 2 screws and pull out the Special
Special Board
(1) According to the slot to which you insert a board, set the Special Board switch.
Installation
(2) Insert the Special Board into the slot along the guide rail and secure using 2 screws.
(3) Connect the cables with the Special Board.
(4) Plug in the power connector. Turn ON the Controller and make sure that the
6.8.2 Adding the Special Board
(1) Turn OFF the Controller and unplug the power connector.
(2) According to the slot to which you insert a board, set the Special Board switch.
(3) Remove 2 screws and remove the panel.
(4) Insert the Special Board into the slot along the guide rail and secure using 2 screws.
(5) Plug in the power connector. Turn ON the Controller and make sure that the
198
Board.
Refer to Maintenance: 11. Option Slots.
Controller starts properly without any vibration or abnormal noise.
Refer to Maintenance: 11. Option Slots.
Controller starts properly without any vibration or abnormal noise.
RC620 Rev.8