Figure 1-1 Vmivme-7807/Vme-7807Rc Pmc Site And Switch Locations - GE VMIVME-7807 Series Hardware Reference Manual

E3 Battery Enable
Jumper installed,
battery enable.
Jumper removed,
battery disabled.
Battery
Enable
S6 Universe II Mapping/ SYSFAIL Generation
S6 Position 1, On = Default
S6 Position 1, Off = NO SYSFAIL after reset
S6 Position 2, On = Default
S6 Position 2, Off = Map UNIV2 to I/O Space
16 VMIVME-7807/VME-7807RC Hardware Reference Manual
Figure 1-1 VMIVME-7807/VME-7807RC PMC Site and Switch Locations
CompactFlash
SODIMM
Pentium-M
Processor
(Enable SYSFAIL generation)
(Map UNIV2 to Memory
S8 NOT USED
(Optional) (Optional)
S1 Position 1, Off = Default
determined by its chassis
S1 Position 1, On = Enables the board to be either the
system controller or non-system controller depending
on S1, position 2's settings.
S1 Position 2, Off = Default
to be system controller regardless of the slot it is
installed
S1 Position 2, On = Forces the board to
non-system controller regardless of the slot it is
installed in.
S7 Position 1, On = Default
S7 Position 1, Off = Disables VME SYSRESET Driver.
S7 Position 2, On = Default
S7 Position 2, Off = Disables VME SYSRESET Receiver.
Tundra
Universe
Space)
S2 CMOS Clear/BIOS Boot Mode
S2 Position 1, Off = Default (Normal Operation)
S2 Position 1, On = Clear CMOS
S2 Position 2, Off = Default (Boot Halt with Post
S2 Position 2, On = Boot with Post Errors
S1 System Controller
(Board's Controller Status -
P1
slot).
(Forces the board
in).
S7 VME SYSRESET
(Enables VME SYSRESET
(Enables SYSRESET
P2 ON
S7
1 2
S7
ON
1 2
Errors)
Driver)
Receiver)