Arm Or Disarm Single Area; Hold-Down Functions; Arm The System In Away Mode; Arm The System In Stay Mode 1 - Bosch Solution 2000 Installation Manual

56 en | System Functions
This feature allows a user assigned to both areas to arm or disarm the system by pressing one
extra button on a partitioned codepad rather than entering a code on each partitioned
codepad. To enable this feature, select Option 2 in Location 501 (refer to Partitioning Options
2, page 144).
To arm or disarm both areas at the same time:
Enter your User Code and press [0][AWAY]. Two beeps sound and both areas are armed or
disarmed from AWAY Mode.
You can also arm/disarm both areas from a common codepad (assigned to both areas) with a
common user code (assigned to both areas).
7.3.2

Arm or Disarm Single Area

See also
–
7.4

Hold-Down Functions

Hold-down functions allow easy activation of specific operations. When you hold down a
button for 2 sec, two beeps sound and the corresponding function operates.
7.4.1

Arm the System in AWAY Mode

Holding down [#] until two beeps sound arms the system in AWAY Mode. This hold-down
function operates only if you select Option 2 in Location 497 (refer to Consumer Options 2,
page 142).
7.4.2

Arm the System in STAY Mode 1

Holding down [*] until two beeps sound arms the system in STAY Mode 1. This hold-down
function operates only if you select Option 2 in Location 497 (refer to Consumer Options 2,
page 142).
If there was no alarm during the armed cycle, holding down [*] a sec time disarms the system
from STAY Mode 1. To enable single button disarming from STAY Mode 1 using this hold-down
function, select Option 4 in Location 497.
If an alarm occurred or entry warning was activated, a valid User Code is required to disarm
the system.
Refer to Zone Options 2, page 101 for information on programming each zone to be
automatically isolated in STAY Mode 1.
7.4.3 Arm the System in STAY Mode 2
Holding down [0] until two beeps sound arms the system in STAY Mode 2. This hold-down
function operates only if you select Option 2 in Location 497 (refer to Consumer Options 2,
page 142).
If no sound alarm occurred during the armed cycle, holding down [0] a sec time disarms the
system from STAY Mode 2. To enable single button disarming from STAY Mode 2 using this
hold-down function, select Option 4 in Location 497.
If an alarm occurred or entry warning was activated, a valid User Code is required to disarm
the system.
For more information, refer to Setting STAY Mode 2 Bypass Zones, page 47.
Notice!
STAY Mode 2 does not work on a partitioned control panel system.
2017.10 | 03 | F.01U.298.026
Arm or Disarm Single Area, page 51
Installation Guide
Control Panel
Bosch Security Systems, Inc.