Zone Report Options - Bosch Solution 2000 Installation Manual

102 en | Zone Information
1 – Isolate in STAY Mode 1
If this option is selected, the zone can be automatically isolated when the system is armed in
STAY Mode 1.
If this option is not selected and the system is armed in STAY Mode 1, the zone activates an
alarm when activated as it normally would in AWAY Mode.
You can specify a global entry time for all zones, except for 24-Hour Zones, when the system is
armed in STAY Mode 1. You program this time in Locations 472 and 473 (refer to Entry Guard
Time for STAY Mode, page 135). The Entry Guard Timer overrides the delay time programmed
for a Delay Zone. If you program the Entry Guard Timer as 0, each zone acts according to its
programmed zone type.
Refer to Arming the System in STAY Mode 1, page 32 for more information.
2 – Zone Isolation Allowed
If this option is selected, the operator can isolate the zone before arming the system. If this
option is not selected, the zone cannot be manually isolated. When a zone is manually
isolated, a Zone Bypass Report (Contact ID Event Code 573) is sent. Refer to Isolating zones,
page 35 for more information.
When a zone is automatically isolated in STAY Mode, a Zone Bypass Report is not sent.
When isolating 24-Hour Zones, the system automatically sends a Zone Bypass Report when the
zone is selected to be isolated. All non-24-Hour zones send a Bypass Report only when the
system is armed.
4 – Forced Arming Allowed
If this option is selected, the system can be armed with the zone unsealed. If this option is not
selected, the system does not allow the User Code holder to arm the system until the zone is
sealed or manually isolated. Refer to Isolating zones, page 35 for more information.
8 – Zone Restore Report
If this option is selected, the zone sends Restore Reports when the zone is restored. If this
option is not selected, the zone does not send Restore Reports when the zone is restored.
If a non-24-Hour zone is not restored when the system is disarmed, the system automatically
sends a Zone Restore Report for that zone. All 24-Hour zones send a Zone Restore Report only
when the zone is restored.
13.3.7

Zone Report Options

By default, a zone reports only to Receiver 1. The table below lists the reporting options for
the zone.
Option
0
1
2
3
4
5
6
7
2017.10 | 03 | F.01U.298.026
Description
No reports allowed
Report to Receiver 1
Report to Receiver 2
Report to Receiver 3
Report to Receiver 4
Report to Receiver 1,2,3,4
Report to Receiver 1 (2,3,4 backup)
Report to Receiver 1 (2 backup) and Receiver 3 (4 backup)
Installation Guide
Control Panel
Bosch Security Systems, Inc.