Zone Pulse Count - Bosch Solution 2000 Installation Manual

Control Panel
8 – 24-Hour Holdup Zone
A 24-Hour Holdup Zone (Contact ID Event Code122) is always ready to activate the horn
speaker, bell, and strobe, whether the system is armed or disarmed. If you want the holdup
alarm to be silent, select Option 4 in the first Zone Options location (refer to Zone Options 1,
page 100). A 24-Hour Holdup Zone does not send a Restore Report until the zone is restored.
9 – 24-Hour Tamper Zone
A 24-Hour Tamper Zone (Contact ID Event Code137) is always ready to activate the horn
speaker, bell, and strobe, whether the system is armed or disarmed. A 24-Hour Tamper zone
does not send a Restore Report until the zone is restored.
11 – Keyswitch Zone
Use a Keyswitch Zone to connect a keyswitch to operate the system. The zone number is
reported as a User Code when arming and disarming using this method of operation, refer to
Keyswitch Zone Options, page 103 for more information. (Contact ID Event Code 409 for
Keyswitch Away Arm and Keyswitch Disarm, 442 for Keyswitch Stay 1 Arm).
12 – 24-Hour Burglary Zone
A 24-Hour Burglary Zone (Contact ID Event Code133) is always ready to activate the horn
speaker, bell, and strobe, whether the system is armed or disarmed. A 24-Hour Burglary zone
does not send a Restore Report until the zone is restored.
13 – 24-Hour Fire Zone
A 24-Hour Fire Zone (Contact ID Event Code 110) is always ready to activate the horn speaker,
bell, and strobe, whether the system is armed or disarmed. A distinct fire sound is emitted
through the horn speaker to indicate this type of alarm. This fire sound is completely different
from the burglary sound. A 24-Hour Fire zone does not send a Restore Report until the zone is
restored.
14 – Chime Zone
A Chime Zone is not a burglary zone. It can never sound the sirens or transmit reports. Its
purpose is to map the zone to a programmable output (refer to 4,5 Global Chime in Output
Event Types, page 123) to indicate if the zone is sealed or unsealed.
Chime zones require EOL resistors and are registered at a codepad. These zones do not affect
the operation of forced arming.
15 –Zone Not Used
If a zone is not used, program the zone type location to 15. An EOL resistor is not required if
this zone type is used. This zone type never sounds the sirens or transmits the reports.
13.3.3

Zone Pulse Count

Zone pulse count is the number of times a zone must be activated before the zone registers an
alarm. The number can vary from 0 to 15. The zone pulse count value is relative to the time
frame (that is, the number of pulses that must be present during a particular time frame).
Zone Pulse Count = 0, means the Zone Pulse Count function is disabled. Refer to Zone Pulse
Count Time, page 100 for more information.
Notice!
A zone that is programmed with a pulse count activates an alarm when it is continuously
unsealed for 10 sec. A 24- Hour Fire Zone programmed with a pulse count activates an alarm
when it is continuously unsealed for 30 sec.
Zone Pulse Count Handover
Zone pulse count handover operates only with Zone Pulse Count Time options 8 to 15.
Bosch Security Systems, Inc. Installation Guide
Zone Information | en 99
2017.10 | 03 | F.01U.298.026