Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
Replacement of the M713 & M714 motors:
Remove / Assembly :
1. Remove the right or left side frame of the machine according to the faulty motor.
2. Move the electric cabinet toward the right to get the motor (felt side).
3. Remove the splash guard.
4. Disconnect the wire of the faulty motor.
5. Release the smoothing belt (see below).
6. Remove the smoothing belt of the drive pulley of the motor.
7. Remove the drive pulley of the motor.
8. Remove the motor of the support and replace it by a new one.
9. Put the drive pulley on the new motor.
10. Put the belt and to tighten up this.
11. Connect the wire on the new motor.
12. Put back the splash guard.
13. Switch on the machine, check the operation of the smoothing and tighten up the belt if
necessary.
14. Put back the frame.
Adjustment of the belt (see next page)
04102011/GB
21-2012
Feeding: Smoothing system
(electricity, steam, water, gas, compressed air...).
29
5