Repair; Replacement Of The Temperature Sensor; Replacement Of The Steam Turning Joint - Electrolux IC4 4819 FFS Service Manual

Service
Manual
Before any intervention it is essential to cut off all supply of the machine

Repair

Replacement of the temperature sensor:

Manometric pressure
in KPa (Bar)
Temperature in °C
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Remove the protection hood.
3. Disconnect the wire of the faulty sensor.
4. Remove the sensor and replace it by a new one.
5. Connect the wire of the new sensor.
6. Put back the protection hood.
7. Put back the frame.

Replacement of the steam turning joint:

Remove / Assembly:
1. Remove the left side frame of the machine.
2. Remove the protection hood.
3. Remove the steam fl exible pipes.
4. Remove the temperature sensor.
5. Remove faulty steam turning joint and replace it by a new one.
6. Put back the temperature sensor.
7. Put back the steam fl exible pipes.
8. Put back the protection hood.
9. Switch on the machine and check the operation of the steam heating.
10. Put back the frame.
04102011/GB
06.2009
Steam heating
(electricity, steam, water, gas, compressed air...).
Correspondence : Steam pressure / Temperature
300 400
(3) (4)
143 151
500 600 700
(5) (6) (7)
158 164 169
26
800 900 1000
(8) (9) (10)
174 179 183
5