Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
Replacement of the A13 gas igniter:
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Disconnect the wire of the faulty gas igniter.
3. Remove the gas igniter and replace it by a new one.
4. Connect the wire on the new gas igniter.
5. Switch on the machine and check the operation of the gas pipe burner.
6. Put back the frame.
Replacement of the KA13 and KA14 relays:
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Disconnect the wire of the faulty relay.
3. Remove the relay of the profi le and replace it by a new one.
4. Connect the wire on the new relay.
5. Switch on the machine and check the operation of the gas pipe burner.
6. Put back the frame
Replacement of the KA2, KA10, KA11 and KA12 relays:
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Remove the faulty relay of the support and replace it by a new one.
3. Switch on the machine and check the operation of the gas pipe burner.
4. Put back the frame.
04102011/GB
50.2011
Gas heating
(electricity, steam, water, gas, compressed air...).
25
17