MIMIC DIAGRAM EDITOR
Pre-configured mimic diagrams
514
Plus
The EnerVista UR
Setup software contains a library of twelve pre-configured mimic
diagrams that can be loaded into the mimic diagram editor. Click the Load button to load a
pre-configured mimic diagram from the library. User-created mimic diagrams can also be
saved into this library. The following pre-configured diagrams are available.
•
Breaker-and-a-half scheme.
•
Breaker-and-a-half scheme with breaker disconnects.
•
Breaker-and-a-half scheme with breaker and line disconnects.
•
Breaker-and-a-half scheme with breaker, line, and ground disconnects.
•
Breaker-and-a-half scheme with line disconnect.
•
Breaker-and-a-half scheme with line and ground disconnects.
•
Double-bus bypass scheme 1.
•
Double-bus bypass scheme 2.
•
Double-bus bypass scheme with line and ground disconnects.
•
Single-bus scheme.
•
Single-bus scheme with line disconnect.
•
Single-bus scheme with line and ground disconnects.
Breakers and disconnect switches are pre-assigned to twelve diagrams shown in the
following figures. If a breaker or disconnect switch has not been enabled, then the device
will display as a solid block.
Figure 442: Pre-configured mimic diagram 1 (breaker-and-a-half scheme)
Figure 443: Pre-configured mimic diagram 2 (breaker-and-a-half scheme with breaker
Figure 444: Pre-configured mimic diagram 3 (breaker-and-a-half scheme, with breaker
disconnects)
PLUS
D90
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 12: LOCAL INTERFACE