GE D90 Plus Instruction Manual page 110

IEC 61850 COMMUNICATIONS
NOTE:
General transmission configuration
GSSE transmission configuration
102
Since GSSE/GOOSE messages are multicast Ethernet by specification, they will not usually
be forwarded by network routers. However, GOOSE messages may be forwarded by
routers if the router has been configured for VLAN functionality.
Select the Settings > Communications > IEC 61850 > GSSE/GOOSE Configuration >
Transmission > General menu item to open the GSSE/GOOSE general transmission
configuration window.
Figure 77: General transmission configuration settings
The following setting is available for GSSE/GOOSE general transmission configuration.
Default GSSE/GOOSE Update Time
Range: 1 to 60 seconds
Default: 60 seconds
This setting specifies the time between GSSE or GOOSE messages when there are no
remote output state changes to be sent. When remote output data changes, GSSE or
GOOSE messages are sent immediately. This setting controls the steady-state heartbeat
time interval.
This setting is applicable to GSSE, fixed D90
Select the Settings > Communications > IEC 61850 > GSSE/GOOSE Configuration >
Transmission > GSSE menu item to open the GSSE transmission configuration window.
Figure 78: GSSE transmission configuration settings
The following settings are available for GSSE transmission configuration.
Function
Range: Enabled, Disabled
Default: Disabled
This setting enables and disables the GSSE transmission functionality.
ID
Range: up to 65 ASCII characters
Default: GSSEOut
This setting represents the IEC 61850 GSSE application ID name string sent as part of
each GSSE message. This name string identifies the GSSE message to the receiving
device.
Plus
GOOSE, and configurable GOOSE.
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: COMMUNICATIONS