Table of Contents
Advertisement
Introduction to DBS 824 Programming
Before Ybu Begin
Before You Begin
This section describes preparations that should be completed before you start
programming. Lf you are familiar with FF key programming
for DB S
systems, you may begin programming
as soon as these preparations
have
been made.
If you are new to DBS programming,
be sure to read
"Understanding FF
Key Programming"
on page Intro-5 before you begin.
. Preparations for Programming
Prior to programming
the DBS 824 system,
make sure you have completed
the following steps:
1.
2.
3.
4.
Confirm that the DBS 824's features meet customer requirements.
DBS
824 feature descriptions are contained in Feature Operation (Section 700)
of this manual.
Confirm that you have the DBS 824 hardware required for the end user.
-
Use Forms and Tables (Section 450) to record the customer's site data.
Use the following guidelines when completing Forms and Tables:
l
Be sure to record all program entries.
l
Leave the default values for equipment
that is not connected.
l
Pay careful attention to program items that require a power-down
to take
effect. Be sure to complete the necessary programming
in these areas
before you make the system operational.
To program,a new DBS 824 system, you must fist initialize the software
to default values (see
"Initializing New Systems",
next page).
Once these steps are completed,. use the site data in Forms and Tables to
program the system.
Issued 3/l 195
DBS 824-l O-400
Intro-3
Advertisement
Chapters
Table of Contents
