Page 1
Panasonic Section 320 DBS 824 to DBS Interconnection (Applies to CPC-AII/B Version 9.2 and CPC-EX Version 2.3) Version 2.3/9.2 Revised April 2000...
Page 2
However, due to ongoing product improvements and revisions, Panasonic cannot guarantee the accuracy of printed material after the date of publication nor can it accept responsibility for errors or omissions. Panasonic will update and revise this document as needed.
Page 3
Table of Contents Introduction ..........................1 Guidelines ............................ 1 Installation ........................... 6 DBS-2.3/9.2-320 DBS Manual - Revised April 2000...
Page 4
DBS Manual - Revised April 2000 DBS-2.3/9.2-320...
Page 5
• Since both DBS and DBS 824 items are used, refer to the installation instructions in both the DBS Section 300 and the DBS 824 Section 300. • If an MFR card is used, it must be installed in the DBS 824 CPC slot. The MFRU card cannot be used.
Page 6
Guidelines Section 320 - DBS 824 to DBS Interconnection Supplement Table 1. DBS 824 Dual Cabinet Feature Considerations CPC-B CPC-B Feature Notes: Auto Repeat Dial Auto Redial Available Personal Speed Dials 10 PSDs/ 10 PSDs/ Extension Extension System Speed Dials...
Page 7
DBS 824 8 (See Note 2.) Notes: 1. When a DBS 40 or DBS 72 is connected to a DBS 824, the expansion ports cannot be used. 2. The DBS 96 cabinet must be used for expansion ports. Figure 1.
Installation Section 320 - DBS 824 to DBS Interconnection Supplement Installation 1. Set SW1 on the CBL-M card according to the following table. Table 3. CBL-M switch settings System Switch Combinations Settings Master Slave DBS 40 DBS 824 ON ON...
Page 11
Section 320 - DBS 824 to DBS Interconnection Supplement Installation Figure 4. DBS to DBS 824 cabinet installation Slave Cabinet RS-232C Digital Deskset Programming Terminal Programming Phone SMDR Printer Filters M D F Li nes RS-232C RS-232C Adapter Master Cabinet (VM, TSAPI, etc.)
Page 12
Section 320 - DBS 824 to DBS Interconnection Supplement Caution: DO NOT connect the Red and Black wires from the CBL-S card to the DBS 824 Power Supply. Connecting the wires may damage the equipment. 5. If the Red and Black wires on the CBL-S card have exposed conductors, separate the wires and cover the exposed conductors on each wire with electrical tape.