Panasonic DBS 824 Installation Manual page 505

Remote Maintenance
System Features
6. Follow the directions on the screen to access the desired programs. (See
"Terminal Programming Commands.")
Note:
The Serial Interface Unit (SIU) supports three functions; 1) Bus
Monitor, 2) SMDR, and 3) Remote Programming. However only one function
can operate at a time. When not in remote programming, either SMDR or a
Bus Monitor is active. When the remote programming mode is entered (by
#/99xxxx), the other function stops. When finished, the SMDR or Bus
Monitor function resumes. You may set the DBS 824 in the desired SMDR or
Bus Monitor mode by entering or have someone on site enter the following
code at an extension or attendant position:
Command Function
,
I #@o I
Normal Bus Monitor on SIU Maintenance Port
I
#91
#I2
Register Bus Monitor on SlU Maintenance Port
Poll Bus Monitor on SIU Maintenance Port
1 SMDR Output on SIU SMDR Port
Terminal Programming Commands
Use the following commands to navigate terminal programming:
Command
Description
-01
Access System parameters
-02
Access Trunk parameters
-03 .
-04
Access Extension parameters
Access Ring assignments
I -05
I Access FF-key assignments
-06
-07
Access Name assignments
Access Toll Restriction data
-08 Access Least Cost Routing data
-09 Access Copy mode
1 Access Speed Dial data
-B
-b
Back to previous address
Back to previous port
L
-F Forward to next address
-f
Forward to next
port
-R
Ctrl-z
Return to previous mode ,
Ouit
.
l-32
DBS 824-l O-700 Issue Date 3/l/95