Cleaning And Lubricating The Drive Chain - Yamaha MT09 Owner's Manual

1
2
1. Notch
2. Alignment marks
3. Drive chain puller
3. Tighten the axle nut, then the lock-
nuts to their specified torques.
Tightening torques:
Axle nut:
150 Nm (15 m·kgf, 108 ft·lbf)
Locknut:
16 Nm (1.6 m·kgf, 12 ft·lbf)
4. Make sure that the drive chain
pullers are in the same position,
the drive chain slack is correct,
and the drive chain
smoothly.
PERIODIC MAINTENANCE AND ADJUSTMENT
Cleaning and lubricating the
3 drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Clean the drive chain with kero-
sene and a small soft brush.
NOTICE: To prevent damaging
the O-rings, do not clean the
drive chain with steam cleaners,
high-pressure washers or inap-
propriate solvents.
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
moves
chain with a special O-ring chain
lubricant. NOTICE: Do not use
engine oil or any other lubri-
cants for the drive chain, as they
EAU23026
ECA10584
[ECA11122]
6-24
may contain substances that
could damage the O-rings.
[ECA11112]
6