Alliance Laundry Systems IPD55E2 Manuals

Manuals and User Guides for Alliance Laundry Systems IPD55E2. We have 3 Alliance Laundry Systems IPD55E2 manuals available for free PDF download: Troubleshooting Manual, Installation Operation & Maintenance

Alliance Laundry Systems IPD55E2 Installation Operation & Maintenance (136 pages)

25 Pound (11.3 Kilogram) Capacity 30 Pound (13.6 Kilogram) Capacity 35 Pound (16 Kilogram) Capacity Stacked 30 Pound (13.6 Kilogram) Capacity Stacked 45 Pound (20.4 Kilogram) Capacity 55 Pound (25 Kilogram) Capacity Starting Serial No. 0602004144

Brand: Alliance Laundry Systems | Category: Dryer | Size: 3 MB

Front Matter
3
Table of Contents
5
Introduction

9
- Model Identification
  9
- Contact Information
  16
Safety Information

17
- Important Safety Instructions
  17
Specifications and Dimensions

19
Installation

38
- Pre-Installation Inspection
  38
- Location Requirements
  38
- Position and Level the Tumble Dryer
  39
- Fifth Leveling Leg
  40
- Fire Suppression System
  40
  - Check Local Codes and Permits
    40
  - Water Requirements
    40
  - Water Connections
    41
  - Electrical Requirements
    42
  - Auxiliary Alarm
    42
- To Reverse the Loading Door (025, 030, 035 and 055 Series)
  42
- Before Placing Tumble Dryer into Service
  44
  - Required for CE Models Only
    46
- Installing CE Gas Drying Tumble Dryer
  47
  - General Information
    47
  - CE Orifices
    47
  - Properties of CE Gases
    50
  - Changing Gas Configuration
    51
  - Specific Conversion Procedures
    52
Exhaust Requirements

55
- Layout
  55
- Make-Up Air
  55
- Venting
  55
  - Individual Venting
    57
  - Manifold Venting
    57
Gas Requirements

61
- Gas Supply Pipe Sizing and Looping
  63
- High Altitude Burner Orifice Sizing
  65
Electrical Requirements

74
Steam Requirements

97
- Piping Recommendations
  99
- Installing Steam Trap and Making Condensate Return Connections
  99
Single Drop Timer

100
- Power-Up Mode
  100
- Ready Mode
  100
- Start Mode
  100
- Run Mode
  100
- Door Open Mode
  100
- End of Cycle Mode
  100
- Setting Dry Time Dipswitches
  100
  - Models through Serial No. 0908Xxxxx
    100
  - Models Starting Serial No. 0909Xxxxx
    100
- Dipswitch Settings
  101
- Topoffs
  105
- Temperature Selector Switch
  105
- To Program a Short Test Cycle
  105
- Error Codes
  106
Operating Instructions

107
- Emergency Stop Button on CE Models
  107
- Reversing Operation
  108
- Control Instructions
  108
  - Dual Digital Timer Control
    108
  - Electronic OPL Micro Control
    110
  - Single Drop Control
    111
  - MDC Coin and Card Control
    112
  - Quantum Control
    113
  - Galaxy 600 Control
    113
  - LED OPL Control
    114
  - Unilinc Control
    116
  - DX4 Coin Control
    117
  - DX4 OPL Control
    117
  - Diagnostic Microprocessor Control
    118
  - DMP OPL Models
    120
  - DMP Coin
    122
- Ignition Control Operation and Troubleshooting for Models Starting 3/11/13
  123
  - Internal Control Failure
    124
  - Troubleshooting
    124
  - Proper Electrode Location
    125
  - Flame Current Measurement
    125
- Ignition Control Operation for Non-CE Models through 3/10/13
  125
- Ignition Control Operation for CE Models through 3/10/13
  126
  - System Tests
    126
  - Diagnostic LED (DGN Led)/Error Codes
    127
Adjustments

128
- Gas Burner Air Shutter
  128
- Airflow Switch
  129
- Loading Door Switch
  129
- Door Strike
  129
Maintenance

131
- Daily
  131
- Monthly
  131
- Quarterly
  132
- Bi-Annually
  132
- Annually
  132
- Fire Suppression System Maintenance Test
  132
Before You Call for Service

134
- Part No. 70458301ENR7 © Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
  135
- Disposal of Unit
  136

Alliance Laundry Systems IPD55E2 Troubleshooting Manual (156 pages)

Brand: Alliance Laundry Systems | Category: Dryer | Size: 5 MB

Table of Contents
3
Section 1 - Safety Information

6
Section 2 - Introduction

9
- Customer Service
  11
- Serial Plate Location
  11
- Wiring Diagram
  11
- How a Tumbler Works
  12
Section 3 - Troubleshooting

13
Section 4 - Adjustments

31
- 15 Loading Door Switch
  
  31
- 16 Loading Door Strike
  
  31
Section 5 - Micro Display Control (MDC) Troubleshooting

32
Section 6 - Netmaster Troubleshooting

63
- Control Suffixes
  63
- 25 No Infra-Red (IR) Communication
  
  63
- 26 Coins Ignored When Entered
  
  64
- 27 Control Has no Display
  
  65
- 28 Door Open Indicator
  
  67
- 29 Motor will Not Start/Run
  
  69
- 30 Unit will Not Heat - Gas
  
  73
- 31 Unit will Not Heat - Steam
  
  76
Section 7 - Hybrid Timer Control Troubleshooting

78
Section 8 - on Premise Micro Control Troubleshooting

109
- Models with OM Control Suffix
  
  109
- 43 Control Has no Display
  
  110
- 44 Door Open Indicator
  
  112
- 45 Motor will Not Start/Run
  
  115
- 46 Unit will Not Heat - Gas
  
  118
- 47 Unit will Not Heat - Steam
  
  121
- 48 Unit will Not Heat - Electric
  
  124
- 49 Error Codes
  
  127
  - Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
    128
Section 9 - Quantum Control Troubleshooting

128
- 50 No Infrared Communication
  
  129
- 51 Coins Ignored When Entered
  
  130
- 52 No Display
  
  131
  - Door Open" Indicator
    133
- 54 No Start/Run
  
  135
- 55 Unit will Not Heat - Gas
  
  137
- 56 Unit will Not Heat - Steam
  
  140
- 57 Unit will Not Heat - Electric
  
  142
- 58 CE Models no Display
  
  145
  - CE Models "Door Open" Indicator
    147
- 60 CE Models no Start/Run
  
  149
- 61 CE Models will Not Heat - Gas/Steam
  
  151
- 62 CE Models will Not Heat - Electric
  
  154

Alliance Laundry Systems IPD55E2 Installation Operation & Maintenance (128 pages)

25 Pound (11 Kilogram) Capacity 30 Pound (13 Kilogram) Capacity 35 Pound (16 Kilogram) Capacity Stacked 30 Pound (13/13 Kilogram) Capacity Stacked 45 Pound (20/20 Kilogram) Capacity 55 Pound (24 Kilogram) Capacity

Brand: Alliance Laundry Systems | Category: Dryer | Size: 2 MB

Table of Contents
5
Introduction

9
- Model Identification
  9
- Contact Information
  15
Safety Information

17
- Explanation of Safety Messages
  17
- Important Safety Instructions
  17
- Tumble Dryer
  18
Specifications and Dimensions

19
Installation

34
- Pre-Installation Inspection
  34
- Location Requirements
  34
- Position and Level the Tumble Dryer
  35
- Fifth Leveling Leg
  36
- Fire Suppression System (Optional Equipment)
  36
  - Check Local Codes and Permits
    36
  - Water Requirements
    36
  - Water Connections
    37
  - Electrical Requirements
    38
  - Auxiliary Alarm
    38
- To Reverse the Loading Door (025, 030, 035 and 055 Series)
  38
- Before Placing Tumble Dryer into Service
  40
  - Required for CE Models Only
    42
- Installing CE Gas Drying Tumble Dryer
  42
  - General Information
    42
  - CE Orifices
    43
  - Properties of CE Gases
    47
  - Changing Gas Configuration
    47
  - Specific Conversion Procedures
    48
Exhaust Requirements

51
- Layout
  51
- Make-Up Air
  51
- Venting
  51
  - Individual Venting
    52
  - Manifold Venting
    53
Gas Requirements

56
- Gas Supply Pipe Sizing and Looping
  58
  - Low Pressure Gas Pipe Sizes
    58
  - High Pressure Gas Pipe Sizes
    60
- High Altitude Burner Orifice Sizing
  62
Electrical Requirements

70
Steam Requirements

92
- Piping Recommendations
  94
- Installing Steam Trap and Making Condensate Return Connections
  94
Single Drop Timer

95
- Power-Up Mode
  95
- Ready Mode
  95
- Start Mode
  95
- Run Mode
  95
- Door Open Mode
  95
- End of Cycle Mode
  95
- Setting Dry Time Dipswitches
  95
  - Models through Serial No. 0908Xxxxx
    95
  - Models Starting Serial No. 0909Xxxxx
    95
- Dipswitch Settings
  96
- Topoffs
  99
- Temperature Selector Switch
  99
- To Program a Short Test Cycle
  99
- Error Codes
  99
Operating Instructions

100
- Emergency Stop Button on CE Models
  100
- Reversing Operation
  101
- Control Instructions
  101
  - Dual Digital Timer Control
    101
  - Electronic OPL Micro Control
    103
  - Single Drop Control
    104
  - MDC Coin and Card Control
    105
  - Quantum Control
    105
  - Galaxy 600 Control
    106
  - LED OPL Control
    107
  - Unilinc Control
    108
  - DX4 Coin Control
    109
  - DX4 OPL Control
    110
  - Diagnostic Microprocessor Control
    110
  - DMP OPL Models
    112
  - DMP Coin
    114
  - Internal Control Failure
    116
  - Troubleshooting
    116
- Ignition Control Operation and Troubleshooting for Models Starting 3/11/13
  116
  - Proper Electrode Location
    117
  - Flame Current Measurement
    117
- Ignition Control Operation for Non-CE Models through 3/10/13
  117
- Ignition Control Operation for CE Models through 3/10/13
  118
  - System Tests
    119
  - Diagnostic LED (DGN Led)/Error Codes
    119
Adjustments

120
- Gas Burner Air Shutter
  120
- Airflow Switch
  121
- Loading Door Switch
  121
- Door Strike
  122
Maintenance

123
- Daily
  123
- Monthly
  124
- Quarterly
  124
- Bi-Annually
  124
- Annually
  124
- Fire Suppression System (Optional Equipment) Maintenance Test
  124
Before You Call for Service

126
- Removing Tumble Dryer from Service
  127
- Disposal of Unit
  128

Alliance Laundry Systems Categories

Washer

Dryer Washer/Dryer Iron Finishers

More Alliance Laundry Systems Manuals

Alliance Laundry Systems IPD55E2 Manuals

Alliance Laundry Systems IPD55E2 Installation Operation & Maintenance (136 pages)

Table of Contents

Introduction

Safety Information

Specifications and Dimensions

Installation

Exhaust Requirements

Gas Requirements

Electrical Requirements

Steam Requirements

Single Drop Timer

Operating Instructions

Adjustments

Maintenance

Before You Call for Service

Alliance Laundry Systems IPD55E2 Troubleshooting Manual (156 pages)

Table of Contents

Section 1 - Safety Information

Section 2 - Introduction

Section 3 - Troubleshooting

1 Tumbler Does Not Start

2 Motor Does Not Start

3 Motor Overload Protector Cycles Repeatedly

4 Motor Runs but Cylinder Does Not Turn

5 Motor Does Not Stop

6 Burner Does Not Ignite

7 Burner Ignites and Goes out Repeatedly

8 Burner Does Not Shut off

9 Clothes Do Not Dry

10 Tumbler Overheating

11 Burner Not Burning Properly

12 Loading Door Opens During Operation

13 Cylinder Continues to Spin with Door Open

14 Coin Does Not Fall into Coin Vault or Coin Drop Sensor Does Not Register that Coin Has Been Entered28

Section 4 - Adjustments

15 Loading Door Switch

16 Loading Door Strike

Section 5 - Micro Display Control (MDC) Troubleshooting

Models with BC, BL, BX and by Control Suffixes

17 Coins Ignored When Entered

18 Control Has no Display

19 Door Open Indicator

20 Motor will Not Start/Run

21 Unit will Not Heat - Gas

22 Unit will Not Heat - Steam

23 Unit will Not Heat - Electric

24 Error Codes

Section 6 - Netmaster Troubleshooting

25 No Infra-Red (IR) Communication

26 Coins Ignored When Entered

27 Control Has no Display

28 Door Open Indicator

29 Motor will Not Start/Run

30 Unit will Not Heat - Gas

31 Unit will Not Heat - Steam

Section 7 - Hybrid Timer Control Troubleshooting

Models with QT, SD and SX Control Suffixes

32 Coins Ignored When Entered

33 Control Has no Display - OPL Models

35 Vend Satisfied, no in Use LED - Coin Models

36 In Use LED Lit, no Motor Run - Coin Models

37 Motor will Not Start/Run - Coin Models

38 Motor will Not Start/Run - OPL Models

39 Unit will Not Heat - Gas - Coin Models

40 Unit will Not Heat - Gas - OPL Models

41 Unit will Not Heat - Electric OPL

42 Error Codes

Section 8 - on Premise Micro Control Troubleshooting

Models with OM Control Suffix

43 Control Has no Display

44 Door Open Indicator

45 Motor will Not Start/Run

46 Unit will Not Heat - Gas

47 Unit will Not Heat - Steam

48 Unit will Not Heat - Electric

49 Error Codes

Section 9 - Quantum Control Troubleshooting

50 No Infrared Communication

51 Coins Ignored When Entered