Placement Of The Mounting Plate; Removing The Mounting Plate; Finding The Wall Studs - Electrolux EI30BM60MS Installation Instructions Manual

PLACEMENT OF THE MOUNTING PLATE

1
.
A REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
Remove the installation instructions,use and care,
1
exhaust adapter, turntable ring, shelf , glass
tray and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
Small Hardware Bag
Turntable
Ring below
glass tray
Fold back all 4 carton flaps fully against carton
2
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
Styrofoam
Pull the carton up and off the oven.
3
Installation Instructions
Exhaust Adapter
Shelf
Glass Tray
Carton
4 Cut the middle of the outer protective plastic bag to
remove the m ounting late
Screws
Mounting Plate
Remove the screws from each end of the mounting
5
plate. This plate will be used as the rear wall template
and for mounting. Reinstall the screws into the holes
where they were removed.
.
B

FINDING THE WALL STUDS

Wall
Studs
Center
1 Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
After locating the stud(s), find the center by
2
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16 (40.6 cm) or 24 (61 cm) from this mark.
3 Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
EN-6
p
Screws